19 - 11 - 2017

Connections and contours

New connection is established when the user left-click with mouse over the block’s input or output, without releasing the mouse button drag the mouse to direction of another input/output, and then release the mouse button over it. If you click over a connection and drag the mouse the line will be broken in two parts. In this way you can make a complex connection from one side of the diagram to another leaving out available graphic elements like blocks, controls, etc. When the user double click over the connection a little square dot will appear. To establish a new connection from this dot on, click over it, wait 2 seconds and then drag the mouse. If you click and immediately drag the mouse, the dot will only be moved. From one dot you can establish many connections.

 

Double click with left mouse button over the connected input/output will disconnect it.